one
two
three
In the Kansas City area, we recommend activating your irrigation system around St. Patrick’s Day because this is typically the time of year when the threat of freezing pipes has passed. Starting up your system is more complicated than just turning on the water. Here are the steps we recommend you go through to get things ready for spring.
The first step in activating your irrigation system is to charge the backflow valve. Switching it to the on position begins to fill the irrigation system with water. If you have a master valve, which we recommend, it will open to pressurize the main line of your system to be ready to run.
You might get wet doing this next step. Turn a zone on and check that the sprinkler heads are in good condition. Watch where the zone spreads water and make sure the sprinkler heads are turned in the correct direction. You want to water the plants, not the concrete or your house. After making sure the heads are watering properly, turn off that zone and start the next one. Continue until you have checked all the zones. You can set up a 1 to 2-minute test cycle also to help make this easier and not have to run back to the controller as much.
Chances are you will have to make some repairs. Mowers hit sprinkler heads, the plastic cracks, or something else broke during the winter. Complete all the repairs, then return to the previous step. When you are satisfied that everything is working, you can move on.
The timer has two functions. You can set it to tell it what days to run and what time to run. Your sprinklers should run in the morning, before 10 a.m. That lets the water dry off the leaves before nightfall. Plants that are wet overnight are more likely to get fungal diseases.
You also need to set how long each zone runs. The run duration depends on temperature and rainfall. If the temperature is high, run the rotor zones so that each zone runs twenty to thirty minutes, and spray zones five to fifteen minutes. If you see water begin to run off then you can scale back the run times and set another start time for later. Shorter run times and more frequent watering allows the water to soak into the soil, so less runs off. If the temperature is cooler, you don’t have to cycle through as many times. Rainfall also means that you may not have to water one of the days you usually water that week, depending on the amount of rainfall. A rain sensor can shut off the system for a period of time so you don’t waste money watering when it is not needed. Smart controllers can also help conserve water and allow you to adjust controls remotely from your phone.
You should check your system in early summer when it starts to get hot. Adjust the timer to water more often so your plants can survive the summer temperatures. Make sure none of the sprinkler heads have been damaged and everything is running smoothly.
Royal Creations Architectural Landscaping can activate your irrigation system for you. We will go through each of the steps and make sure your system is running efficiently and is set correctly. In fact, we have a new Lawn Sprinkler Subscription Program. The Fresh Impressions level includes sprinkler activation, a system inspection at activation, a summer season system inspection, and winterization. The Luscious Landscape level includes all that plus two additional seasonal system inspections, a zone diagram, and 5% off all repairs. Finally, the Royal Treatment level includes sprinkler activation, system inspection at activation, four seasonal system inspections, six remote adjustments of the sprinkler during the season, winterization, zone diagram, and priority scheduling. Royal Treatment clients will also get 10% off of all repairs. To fully take advantage of this level of service, you must have a Wi-Fi-smart controller, which may require a one-time additional fee. To enroll, call the office at (816) 825-2524 today.
© 2020 Royal Creations Architectural Landscaping
Terms and Service | Privacy Policy | Careers | Site Map | Warranty
